Northumbrian Windsurfing

Northumbrian Windsurfing
https://forum.northumbrianwindsurfing.com/

CAN’T GET IT OUT (and I’m sure it’s not the boards fault)

https://forum.northumbrianwindsurfing.com/viewtopic.php?f=10&t=1106

Page 1 of 1

CAN’T GET IT OUT (and I’m sure it’s not the boards fault)

Unread postPosted: Thu Aug 08, 2019 4:54 pm
by Old14Crew
MISTRAL ONE DESIGN RACE manuf no.78012077

So I slotted my centre board into the cb casing. All went well until I tried to remove it after sailing.

The board goes fully down but on bringing it back into the cb case to remove, most of the board and both the red and blue buttons are visible but the c. board refuses to come out of the cb case.

Suggestions would be appreciated.

Re: CAN’T GET IT OUT (and I’m sure it’s not the boards fault

Unread postPosted: Sun Aug 11, 2019 8:12 am
by dave d
Hi ..... I can't help you with removing the dagger board ... however if its stuck for good why not take my Starboard Carve 122ltr for a nominal charge ( I have to pack in windsurfing due to injury ), and try that. Alternatively if you know anyone who might want / need some kit please get in touch. I also have a number of sails and masts that have to go.

Dave D

Re: CAN’T GET IT OUT (and I’m sure it’s not the boards fault

Unread postPosted: Sat Nov 09, 2019 8:19 pm
by Old14Crew
Problem solved. Cut out the original pivot pin and fabricate replacement!